The story of Ceramic Super REDS is simple. Take the superior steels used in our Super REDS and swap the steel balls for grade 5, silicone nitrade, hot isostatically pressed ceramic balls and you have Bones Ceramic Super REDS.
Bones Ceramic Super REDS are lighter and provide faster acceleration because the balls weigh much less. They create less friction and are thus faster than Super REDS, with or without lubricant! When you get dirt into your Ceramic Super REDS, the ceramic balls will help to re-polish the steel races flat again, providing a self-healing benefit because ceramic balls are so much harder than steel. Finally, ceramic balls will not rust, further lengthening their life. Ceramic Super REDS use a bone colored shield with laser-engraved outer races for identification.
Bones Bearings - 8mm Bones REDS Ceramic Skateboard Bearings (8) Pack Features:
- Features grade 5, silicone nitride, hot isostatically pressed ceramic balls.
- Higher quality steel races and a superior surface finish.
- Single non-contact removable rubber shield for easy cleaning and less friction.
- High speed nylon ball retainer for greater strength and speed.
- Pre-lubricated with Bones Speed Cream™ racing lubricant.
- Skate Rated clearances, tolerances, materials and lubricant provide the best performance and durability possible.
Bones Bearings - 8mm Bones REDS Ceramic Skateboard Bearings (8) Pack Contents:
- Set of 8 bearings
As a proud owner of Bones Bearings, now check out tips on Maintaining and Cleaning your Bones Bearings.
Keep your Bones Bearings rolling fast and smooth with Bones Bearings Speed Cream.
How to Buy Skateboard Bearings
What size skateboard bearings do I need for my skateboard wheels?
All skateboard bearings are the same size, so you don't need to worry about size when selecting bearings.
Skateboard bearings are used to mount the skateboard wheels to the skateboard axle. Skateboard bearings are all the same size and will fit any skateboard wheel that Warehouse Skateboards sells.
While they do not vary in size, they do vary in quality. The rule of thumb tends to be that the more expensive the skateboard bearings, the higher the quality. Cheaper bearings are typically made of lower quality materials, which can get deformed or break completely under the pressure of skateboarding. Inexpensive bearings may also not be sealed as well, resulting in dirt and debris in your bearings that will slow your board down dramatically. The more expensive skateboard bearings are sealed, with higher precession machining, and higher-quality metals. They will remain fast and precise over time with proper maintenance.
Most bearings are measured by an ABEC rating. The higher the ABEC rating, the more accurate and precise the bearing will be. This rating system includes grades 1, 3, 5, 7, and 9. The ABEC rating does not specify many critical factors, such as load handling capabilities, ball precision, materials, material Rockwell hardness, degree of ball and raceway polishing, noise, vibration, and lubricant. Due to these factors, an ABEC 3 classified bearing could perform better than an ABEC 7 bearing.
Many companies do not use the ABEC rating scale, such as Bones Bearings. Bones Bearings uses their own rating system known as Skate Rated. These bearings do not follow the ABEC ratings because they are superior in quality and the ABEC rating ignores many quality factors in which Bones Bearings prides itself.